Diagnosis & Leak Detection
Pressure testing and an electronic sweep before any gas is added.
Weaker cooling than last summer usually means one thing: refrigerant has escaped through a leak. We find it, fix it, and recharge the system to the manufacturer's exact spec.
An air conditioning gas refill is the process of pressure-testing a system, locating and repairing any refrigerant leak, then recharging the circuit with the correct weighed amount of R32, R410A or R22 gas. It is needed when a unit is cooling weakly or has iced up, not as routine annual servicing. In Valencia, Square Meter charges from EUR 120 for a refill, with most single-unit jobs completed the same day.
A refill isn't just connecting a cylinder and squeezing gas in until the pressure looks right. Done properly, it starts with finding out why the system is low in the first place — because on a sealed refrigerant circuit, low gas is a symptom, not a normal wear item.
From the first pressure reading to the paperwork we leave behind, here's what our engineers actually do on a typical visit.
Pressure testing and an electronic sweep before any gas is added.
Leaking joints and fittings repaired properly before recharging.
Costs confirmed up front, so the invoice matches what you agreed to.
A slow leak rarely announces itself. It shows up as a gradual loss of performance that's easy to write off as "the heat" until you compare it to how the unit cooled when it was new.
The order matters: we test and repair before we recharge, because refilling first would mean paying for gas that simply leaks back out.
Describe the symptoms by phone or WhatsApp; most visits are scheduled within a day.
We check system pressures and sweep every joint and coil with an electronic detector.
Any leaking joint, valve or pipe found is repaired or re-flared before we go further.
The circuit is pulled down to a deep vacuum to remove trapped air and moisture.
Refrigerant is weighed in to the exact specification for your unit's model and capacity.
We verify temperatures and pressures, then leave you a written summary of the work.
A refill on its own, with no leak found, sits at the lower end of what a repair visit costs. Where a leak needs fixing, that work is quoted alongside the refill so there are no surprises on the invoice.
Pressure test, weighed recharge and performance check for one indoor unit.
Waived if a repair goes ahead; covers a full leak search and written findings.
Catches slow leaks and dirty coils before they turn into a no-cooling call-out.
We're the air conditioning arm of Square Meter, a Valencia renovation, plumbing and electrical group, so our engineers are used to working carefully inside finished homes — not just around bare pipework. Every gas refill is carried out by a certified, insured technician using calibrated weighing equipment, never "by feel."
We carry pressure-testing and refrigerant recovery equipment on every van, so most gas refill callouts across the following areas are handled in a single visit.
The questions we hear most often from Valencia homeowners and landlords booking a refill.
A refrigerant gas refill starts from EUR 120 in Valencia. The final price depends on the refrigerant type, how much gas is needed to reach a full charge, and whether a leak repair is required first, and Square Meter always confirms the exact cost in a written quote before any work begins.
Air conditioning systems are sealed circuits and do not consume refrigerant during normal use, so a unit that has run low on gas almost always has a leak somewhere in the pipework, coil or fittings rather than having simply used up its original charge.
Square Meter does not recommend topping up refrigerant without first locating the leak, because an unrepaired leak will let the new gas escape again within weeks or months, wasting the cost of the refill and risking compressor damage from running low on charge.
Most air conditioning systems installed in Valencia over the last several years run on R32 refrigerant, older systems typically use R410A, and units installed before the mid-2000s may still use the now-phased-out R22; Square Meter confirms the exact type from the unit's data plate before refilling.
A straightforward refill with no leak found typically takes 45 to 90 minutes per indoor unit, covering pressure testing, evacuation and weighing in the correct charge, while a visit that also involves finding and repairing a leak usually takes longer.
Gas refills carried out by Square Meter are backed by the standard 2-year written workmanship warranty, so if a leak repaired during the same visit reopens within that period, the follow-up diagnosis and re-repair are covered.
Low refrigerant is one of several reasons an AC unit stops performing — these related pages cover the rest.
Call or WhatsApp Square Meter for a pressure test and, where needed, a weighed refrigerant recharge with a full leak check — backed by a 2-year written workmanship warranty.